Wan, M; Schröder, C; Peiffer, S: Fe(III):S(-II) Concentration Ratio Controls the Pathway and the Kinetics of Pyrite Formation during Sulfidation of Ferric Hydroxides, Geochim. Cosmochim. Acta, 2017, 334-348 (2017), doi:https://doi.org/10.1016/j.gca.2017.08.036 [Link]
Abstract:
The formation of pyrite has been extensively studied because of its abundance in many anoxic environments. Yet, there is no consensus on the underlying pathways and kinetics of its formation. We studied the formation of pyrite during the reaction between reactive ferric hydroxides (goethite and lepidocrocite) and aqueous sulfide in an anoxic glove box at neutral pH. The formation of pyrite was monitored with Mössbauer spectroscopy using 57Fe isotope-enriched ferric (hydr)oxides. The initial molar ratios of Fe(III):S(-II) were adjusted to be ‘high’ with Fe(III) concentrations in excess of sulfide (HR) and ‘low’ (LR) with excess of sulfide. Approximately the same surface area was applied in all HR runs in order to compare the mineral reactivity of ferric hydroxides. Electron transfer between aqueous sulfide and ferric hydroxides in the first 2 hours led to the formation of ferrous iron and methanol-extractable oxidized sulfur (MES). Metastable FeSx formed in all of the experiments. Pyrite formed at a different rate in HR and LR runs although the MES and ferrous iron concentrations were rather similar. In all HR runs, pyrite formation started after 48 hours and achieved a maximum concentration after 1 week. In contrast, pyrite started to form only after 2 months in LR runs (Fe(III):S(-II) ~ 0.2) with goethite and no pyrite formation was observed in LR with lepidocrocite after 6 months. Rates in LR runs were at least 2-3 orders of magnitude slower than in HR runs. Sulfide oxidation rates were higher with lepidocrocite than with goethite, but no influence of the mineral type on pyrite formation rates in HR runs could be observed. Pyrite formation rates in HR runs could not be predicted by the classical model of Rickard (1975). We therefore propose a novel ferric-hydroxide-surface (FHS) pathway for rapid pyrite formation that is based on the formation of a precursor species >FeIIS2-. Its formation is competitive to FeSx precipitation at high aqueous sulfide concentrations and requires that a fraction of the ferric hydroxide surface not be covered by a surface precipitate of FeSx. Hence, pyrite formation rate decreases with decreasing Fe(III):S(-II)aq ratio. In LR runs, pyrite formation appears to follow the model of Rickard (1975) and to be kinetically controlled by the dissolution of FeS. The FHS-pathway will be prominent in many aquatic systems with terrestrial influence, i.e. abundance of ferric iron. We propose that the Fe(III):S(-II)aq ratio can be used as an indicator for rapid pyrite formation during early diagenesis in anoxic/suboxic aquatic systems.
Aktuelle Termine


BayCEER-Kolloquium:
Do. 25.04.2024
Perspectives and challenges in the restoration and conservation of two isolated habitats: gypsum and cliffs
BayCEER Short Courses:
Mi. 24.04.2024
Mobile Film Making Workshop (for PhDs/PostDosc/Profs of BayCEER)
Fr. 26.04.2024
Mobile Film Making Workshop (for students of BayCEER)
Ökologisch-Botanischer Garten:
So. 21.04.2024
Führung | Den ÖBG kennenlernen: Allgemeine Gartenführung
Fr. 26.04.2024
Aktion | Kräuterreich & regional: Backkunst im ÖBG (zus. mit HWK)
Wetter Versuchsflächen
Luftdruck (356m): 963.4 hPa
Lufttemperatur: 4.5 °C
Niederschlag: 0.0 mm/24h
Sonnenschein: <1 h/d

...mehr
Lufttemperatur: 0.9 °C
Niederschlag: 0.0 mm/24h

...mehr
Diese Webseite verwendet Cookies. weitere Informationen